Kenco-engineering Accu-Rate Pump Setting Gauge Bedienungsanleitung PDF herunterladen

KENCO ACCU-RATE PUMP SETTING GAUGE®

INSTALLATION AND OPERATING INSTRUCTIONS

Install pipe fittings into gauge by rigidly clamping the END PLATE that is to have piping

installed. Tighten the pipe fittings into the threaded connection of this END PLATE.

GLASS SIGHT TUBE will BREAK if the END PLATE is not HELD RIGIDLY to eliminate

any TWISTING.

GAUGE MUST BE INSTALLED SO GRAVITY WILL FILL THE GAUGE.

To check pumping rate, open VALVE “B” to fill the pump setting gauge. When the

gauge is filled, close VALVE “A” for one minute and note the level in the gauge at the

beginning of the test and at the end of the test. Count the number of marks on the rate

scale that the level dropped. This is the pump rate.

58270

(12-22-11)

1 2

KENCO ACCU-RATE PUMP SETTING GAUGE® INSTALLATION AND OPERATING INSTRUCTIONS Install pipe fittings into gauge by rigidly clamping the END PLATE that

Seite 2

KENCO ACCU-RATE PUMP SETTING GAUGE® Model PSG0180, PSG0404, PSG0720, PSG1620 and PSG2880 Sight Tube Installation Instructions 1. Apply a small amou

Keine Kommentare

Kenco-engineering Accu-Rate Pump Setting Gauge Bedienungsanleitung